We take emergency roof calls

Flat Roof Repair in Brooklyn, NY: Leaks, Seams, Blisters and Drains Fixed Right

A leaking flat roof is the most common call we get. Usually the problem is one seam, one flashing detail or one clogged drain, not the whole roof. All State Roofing – Brooklyn has been finding and fixing flat roof leaks on brownstones, rowhouses, walk-ups and commercial buildings since 1997, and we’ll tell you honestly when a repair is enough.

  • Brooklyn roofers since 1997
  • We find the real entry point
  • Photos of what we find and fix
  • Competitive rates
The honest answer

Can Your Flat Roof Be Repaired, or Does It Need Replacing?

Short answer: most flat roof leaks in Brooklyn can be repaired, because most start at a single detail: an open seam, a split at a parapet, a failed pipe boot or a clogged drain. A repair stops being honest when the insulation under the membrane is soaked, the surface is blistered and cracked everywhere, leaks keep appearing in new places, or the roof already has two layers. At that point, patching just traps water under a new piece of membrane.
A repair makes sense when…A repair is money wasted when…
The leak traces to one seam, flashing or penetrationLeaks show up in a different spot every few storms
The insulation and deck around it are dry and firmThe roof feels soft or spongy underfoot
The membrane is still flexible and intact elsewhereBlisters, splits and alligator cracking cover most of the roof
A single puncture from a dropped tool or a fallen branchThere are already two or more roofs on the building
A drain or scupper is clogged or its flashing has failedSomeone wants to coat over a roof that’s wet underneath

If it’s past repairing, here’s how a proper roof replacement in Brooklyn works.

Diagnosis

Common Flat Roof Problems We Repair in Brooklyn

What you see, what’s usually behind it, and what a proper repair looks like.

What you noticeLikely causeProper repair
Leak in heavy rain onlyA partly clogged drain or scupper, or flashing set too low, so water overflows once it poolsClear and reflash the drain; raise or replace the flashing
Leak along a top-floor wallParapet, coping or party-wall flashingNew flashing and counterflashing; reset or reseal coping
Leak around a skylight or hatchCurb flashing or a dried-out frame sealReflash the curb; reseal or repair the frame
Leak under a vent pipe or exhaust fanA cracked pipe boot or failed penetration flashingNew boot or penetration flashing
Bubbles or blisters in the roof surfaceTrapped moisture or air between layersBlister cut out, dried and patched; widespread blistering means replacement
Rubber pulling away at the edgesEPDM shrinkage or adhesive failureEdge and flashing re-secured and seamed
Open lap or seamFailed seam tape, adhesive or weldSeam cleaned, primed and resealed, or re-welded on TPO and PVC
Cracking like dried mudAged, UV-worn bitumen or coatingSmall areas repaired; a surface cracked all over needs a new roof
Leak detection

How We Find a Flat Roof Leak

Patching the spot above the stain is how most flat roof repairs fail. Water on attached buildings travels along roof boards, joists and party walls before it shows up inside.

  1. 01

    We ask how it leaks

    Every rain, heavy rain only, wind from one direction, or after snow melts? The pattern points to the cause before we’re even on the roof.

    What the pattern tells us

    Heavy rain only usually means drainage. Wind-driven rain usually means flashing or coping. Every rain, even light, usually means a hole in the membrane.

  2. 02

    We look inside first

    Where the stain is, how big it is, whether it’s along a wall or in the middle of the ceiling, and what’s directly above and upslope of it.

  3. 03

    We inspect the whole roof

    Seams, flashing, parapets, coping, party walls, drains, scuppers, skylights, the bulkhead and every penetration, plus soft spots that suggest wet insulation. We photograph what we find.

  4. 04

    We confirm before we fix

    When the cause isn’t obvious, a controlled water test, wetting one area at a time while someone watches inside, can pin it down.

  5. 05

    We repair it with matching materials

    EPDM is repaired with EPDM, TPO and PVC are welded, and modified bitumen gets compatible plies, so the repair bonds to the roof instead of fighting it. You get before-and-after photos.

Where flat roofs fail

Flat Roof Repairs by Part of the Roof

Seam repair

Seams are the weak point of single-ply roofs. We clean, prime and reseal open laps on EPDM, and re-weld TPO and PVC seams.

Parapet and party-wall flashing

The most common source of wall leaks on brownstones and rowhouses. New flashing turned up the wall and counterflashed, with coping reset where it’s loose.

Drain and scupper repair

Clogged, cracked or poorly flashed drains cleared, reflashed or replaced, so the roof empties instead of ponding.

Skylight and hatch repair

Curbs reflashed, frames resealed, and hatches repaired so they close tight.

Penetrations and pipe boots

New boots and flashing at vent pipes, exhaust fans, HVAC curbs and old antenna or satellite mounts.

Blisters, cracks and punctures

Cut out and patched with compatible material, after checking the insulation underneath is dry.

Brooklyn weather

Why Brooklyn Flat Roofs Leak When They Do

Cloudbursts

The remnants of Hurricane Ida dropped 3.15 inches of rain in one hour in Central Park in September 2021, and July 14, 2025 brought 2.07 inches in an hour. NYC DEP has said most sewers handle about 1.5 to 1.75 inches an hour. A rowhouse roof with one half-clogged drain can’t keep up.

Freeze-thaw

Water in a cracked coping joint or an open seam freezes, expands and opens the gap a little more each winter. Leaks often show up during the first spring storms.

Summer heat

Dark flat roofs bake in July and August. Heat ages bitumen and sealants and feeds blisters where moisture is trapped.

Coastal wind

Hurricane season runs June 1 to November 30, and nor’easters follow. Wind lifts membrane edges and loose flashing, especially near the water in Coney Island, Sheepshead Bay and Gerritsen Beach.

NYC rules

NYC Rules That Apply to Flat Roof Repairs

Do flat roof repairs need a permit?

Ordinary repairs above the roof deck generally don’t need a Department of Buildings permit. Replacing any of the deck or sheathing does.

Torch repairs

Torch-applied repairs on modified bitumen need operators with FDNY Certificates of Fitness and an F-60 fire guard on fire watch.

Licensed contractors

Home improvement work over $200 on a residence requires a DCWP license. Check a contractor by calling 311 or on nyc.gov/dcwp.

Leaks in rentals

Tenants can report leaks to 311. HPD gives 30 days to correct a Class B violation and 24 hours for a Class C one.

Parapets

Buildings with parapets facing a street or sidewalk need an annual observation, except detached one- and two-family homes. We repair what the observation finds.

Neighbors’ roofs

If a repair needs access through a neighbor’s roof and they refuse, New York’s RPAPL 881 lets a court grant access for necessary work.

Service area

Flat Roof Repair Across Brooklyn

From Greenpoint to Coney Island, and nearby parts of Queens, Staten Island and Manhattan.

Brownstone Brooklyn

Park Slope, Brooklyn Heights, Cobble Hill, Carroll Gardens, Boerum Hill, Fort Greene, Clinton Hill, Prospect Heights

112151120111231112171120511238

Central and North Brooklyn

Bed-Stuy, Crown Heights, Bushwick, Williamsburg, Greenpoint, Flatbush, East Flatbush

1121611221112131123711211112221122611203

South Brooklyn

Sunset Park, Bay Ridge, Dyker Heights, Bensonhurst, Borough Park, Midwood, Sheepshead Bay, Coney Island, Canarsie

11220112321120911228112141121911230112291122411236

Why All State Roofing

Why Brooklyn Calls All State Roofing – Brooklyn for Flat Roof Repair

  • Since 1997 on the borough’s flat roofs.
  • We find the cause, not just the stain.
  • Honest repair-or-replace advice, with photos to back it up.
  • Matching materials for EPDM, TPO, PVC and modified bitumen.
  • Competitive rates and checks accepted.

Pitched roof leaking instead? See our general roof repair services.

“They are understanding and a professional company. The job was done on time and left very clean. Thank you Allstate Roofing.”
Alejandro C., Staten Island · Yelp, October 2016

Flat roof leaking?

Tell us how it leaks and we’ll find where it’s coming in.

Call a Roofer
FAQ

Flat Roof Repair in Brooklyn: FAQs

Can my flat roof be repaired or does it need replacing?

Most flat roof leaks can be repaired because they start at a single seam, flashing, penetration or drain. Replacement makes more sense when the insulation is soaked, the surface is blistered and cracked everywhere, leaks keep moving, or the roof already has two layers.

Why does my flat roof leak only in heavy rain?

Usually because water is overflowing somewhere rather than soaking through the membrane. A partly clogged drain, an undersized scupper or flashing set too low lets water over the top once it pools.

Why is the leak nowhere near the stain on my ceiling?

On attached Brooklyn buildings, water often travels along roof boards, joists and party walls before it shows up inside. That’s why we inspect the whole roof rather than patching the spot above the stain.

Can you patch a rubber (EPDM) roof?

Yes. Open seams, punctures and edge problems on EPDM can be cleaned, primed and repaired with compatible EPDM materials, as long as the roof around the repair is sound and dry.

What causes blisters on a flat roof, and should they be fixed?

Blisters form where moisture or air is trapped between layers, and heat makes them grow. A few blisters can be cut out and repaired once the area is dry. Blistering across most of the roof usually means it’s time to replace it.

Do I need a permit for a flat roof repair in NYC?

Ordinary repairs above the roof deck generally don’t need a Department of Buildings permit. Replacing any of the deck or sheathing does. Torch-applied repairs also need FDNY-certified operators and a fire guard.

Is a coating a good fix for a leaking flat roof?

Not on its own. A coating can’t seal a failed seam or flashing, and over wet insulation it traps the water. The leak needs to be found and repaired first; a coating only makes sense on a sound, dry roof.

How can I prevent flat roof leaks?

Keep drains and scuppers clear, especially in fall, have the roof inspected in spring and fall, fix small seam and flashing problems early, and stay off the roof surface as much as possible.

Sources

NYC DOB (1 RCNY 101-14; 1 RCNY 103-15; NYC Building Code §1511.3.1.1), FDNY, NYC DCWP, NYC HPD, NYC DEP, National Weather Service, New York RPAPL 881, NRCA. Last reviewed October 2026.

Get Your Brooklyn Flat Roof Repaired the Right Way

All State Roofing – Brooklyn finds the real source of the leak and fixes it with the right materials. Local flat roof repair since 1997.

All State Roofing – Brooklyn

235 43rd St, Brooklyn, NY 11232

(929) 695-6095

Emergency roof calls taken

Tap to Call a Roofer